Twisted Hobbys Veloxity Manual page 13

A cody wojcik design
Table of Contents

Advertisement

While the previous step is drying, locate
the ber glass parts tree.
Under side of the assembly. Note that it
is the near side of the center piece that
is roughed up.
Rev: 2015.11.30.v01a
Break out the 3 landing gear base parts
as pictured above. Roughen up the legs
of the two side pieces and one complete
side of the center piece.
Make sure it is all realitevly square.
Once one of the side pieces is attached,
repeat for the other side. Note
orientation is critical, make sure you
have matched these pictures.
Take a close look at the the next three
pictures to get the right orientation of
the parts. Hold with your nger tips
and apply a little thin CA and hit with
Kicker
Finished assembly, note the glue joint
does not have to be super robust, but
good enough to hold things together
during assembly into the fuselage.
page 13

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Veloxity and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents