Driving On A Slope; Driving To / From The Field; Warning For Driving On The Road; Operating Tips For Power Steering - Zetor COMPAX CL Series Operator's Manual

Driving on a Slope

When driving on a slope, set the main gear shift lever to a low gear to prevent the engine from stopping.
When driving downhill, use the braking effect of the engine. Never set the main gear shift lever
to the neutral position or drive with the clutch pedal depressed.
Keep the speed low when driving downhill.

Driving to / from the Field

Connect the left and right brake pedals.
It is dangerous to enter / leave the field if the field is well below the balk. Use ramps if necessary.
Move perpendicular to the balk.
To use full power, it is recommended to reverse into the field.
CAUTION:
When working in hilly terrain, the risk of machine damage - rolling over and injury - is

significantly increased. Environmental conditions must be taken into account.
When towing trailers and semi-trailers in hilly terrain, make sure that the brakes of these

machines are in working order and in perfect condition. To drive down the hill, use the braking
action of the engine in combination with a lower gear.

Warning for Driving on the Road

When changing the direction of travel on the road, always use turn signal lights.
Always keep the brake pedals connected.
When driving at night, switch off the work lights.
Dim the tractor lights when meeting another vehicle at night.
Make sure that the lights are adjusted to avoid dazzling the eyes of the oncoming vehicle driver.
No one but the driver may ride on the tractor.
Follow all applicable regulations and drive safely.

Operating Tips for Power Steering

1. The power steering is only active when the engine is running. Steering wheel operation can be more
difficult at lower engine speeds.
2. In the event of a front axle load (loader work, weight aggregation), it may be harder to turn the steering
wheel with the tractor stationary. In this case, turn the steering wheel while driving the tractor at low speed.
3. An audible sound is heard when the steering wheel is turned to the end position. Avoid holding the
steering wheel in the end positions for a long time.
4. Unnecessary turning of the steering wheel to its end positions (with the tractor stationary) wears out the
tires.
5. In winter, warm the engine sufficiently before driving.
6. Repair hydraulic components such as hoses or pipes in a clean environment. Prevent dirt from entering
the system.
7. Keep your hands on the steering wheel while driving.
Releasing the steering wheel while driving can result in an accident and injury.
Check During Driving
Constantly monitor the warning lights on the dash and if any comes on stop the tractor to determine the
cause.
68
DRIVING OPERATION