Checks And Service; General Information; Periodical Check And Service Table - Zetor COMPAX CL Series Operator's Manual

Hide thumbs Also See for COMPAX CL Series:
Table of Contents

Advertisement

Checks and Service

General Information

This section provides detailed information about the service procedures necessary to maintain trouble-free
operation of the machine. Specific values for individual tasks can be found in the attached table.
Service Inspections
Service inspections are performed as follows:
The first service inspection when the hour meter is at a maximum of 50 hours of operation, but no later than
within 6 months from the commissioning of the tractor.
The second service inspection after another 450 hours of operation (with a maximum of 500 hours of
operation), but no later than 12 months after the first service inspection.
Further service inspections always after another 500 hours of operation, but no later than 12 months from the
previous service inspection.
Engine Oil and Filter Change
The first change of the engine oil when the hour meter is at a maximum of 50 hours of operation, but no later
than within 6 months from the commissioning of the tractor.
The second change of the engine oil after another 200 hours of operation (with a maximum of 250 hours of
operation), but no later than 12 months after the first service inspection.
Further engine oil changes, always after another 250 hours of operation, but no later than 12 months after
the previous service inspection.
Performing service inspections is part of tractor maintenance.
Authorized Zetor services will provide you with professional inspections according to the manufacturer's
instructions.

Periodical Check and Service Table

Caution: These intervals are for operation under normal conditions and need to be reviewed
under severe conditions to a greater frequency.
O Check, top-up or adjust,
X Replace,
XX First replacement
Unit
Item
Engine oil and
filter
Fuel filter
cleaning /
replacement
Coolant
Engine
Air Filter
V-belt
Battery
Hoses and
clamps
72
MAINTENANCE
Service interval (hour meter, mark)
Daily
50
100
200
o
xx
o
o
o
o
o
o
o
250
300
400
500
x
x
x
o
o
x
o
o
o
o
o
Note:
600
Exchange every
250 hours of
operation / year
Every two years
o
Replacement as
needed
o
Replacement as
needed

Advertisement

Table of Contents
loading

This manual is also suitable for:

Compax cl 35 ncCompax cl 40 nc

Table of Contents