Table of Contents
Advertisement
2.4.1 Using The Reset Button
Step 1.
Step 2.
2.4.2 Uploading a Configuration File Via Console Port
Download the default configuration file from
http://www.nortelnetworks.com/index.html, unzip it and save it in a folder.
Step 1.
Step 2.
Step 3.
Step 4.
Make sure the SYS LED is on (not blinking).
Press the RESET button for about five seconds, and then release it.
When the SYS LED begins to blink, the defaults have been restored and
the Contivity 251 restarts
Turn off the Contivity 251, begin a terminal emulation software session
and turn on the Contivity 251 again. When you see the message "Press
Any key to enter Debug Mode within 3 seconds", press any key to enter
debug mode.
Enter "atlc" after "Enter Debug Mode" message.
Wait for "Starting XMODEM upload" message before activating
Xmodem upload on your terminal. This is an example Xmodem
configuration upload using HyperTerminal.
Click Transfer, then Send File to display the following screen.
Introducing the WebGUI 2-5
Contivity 251 VPN Switch User's Guide
Advertisement
Table of Contents
