Table of Contents
Advertisement
27-2 Bridging Setup
parameters, you need to configure Menu 11.3 – Remote Node Network Layer
Options.
To setup Menu 11.3 – Remote Node Network Layer Options shown in the next
figure, follow these steps:
Step 1.
Figure 27-1 Menu 11.1 Remote Node Profile
Menu 11.1 - Remote Node Profile
Rem Node Name= ?
Active= Yes
Encapsulation= ENET ENCAP
Multiplexing= VC-based
Service Name= N/A
Incoming:
Rem Login= N/A
Rem Password= N/A
Outgoing:
My Login= N/A
My Password= N/A
Authen= N/A
Press ENTER to Confirm or ESC to Cancel:
Step 2.
Figure 27-2 Menu 11.3 Remote Node Network Layer Options
Menu 11.3 - Remote Node Network Layer Options
IP Options:
IP Address Assignment = Static
Rem IP Addr = 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= 0.0.0.0
NAT= SUA Only
Address Mapping Set= N/A
Metric= 2
Private= No
RIP Direction= Both
Version= RIP-2B
Multicast= None
IP Policies=
Enter here to CONFIRM or ESC to CANCEL:
317516-A Rev 00
In menu 11.1, make sure the Bridge field is set to Yes.
Route= IP
Bridge= Yes
Edit IP/Bridge= Yes
Edit ATM Options= No
Telco Option:
Allocated Budget(min)= N/A
Period(hr)= N/A
Schedule Sets= N/A
Nailed-Up Connection= N/A
Session Options:
Edit Filter Sets= No
Idle Timeout(sec)= N/A
Move the cursor to the Edit IP/Bridge field, then press [SPACE
BAR] to set the value to Yes and press [ENTER] to edit Menu 11.3 –
Remote Node Network Layer Options.
Bridge Options:
Ethernet Addr Timeout(min)= N/A
Advertisement
Table of Contents
