Table of Contents
Advertisement
25-6 Remote Node Configuration
25.2.3
Outgoing Authentication Protocol
For obvious reasons, you should employ the strongest authentication protocol
possible. However, some vendors' implementation includes specific
authentication protocol in the user profile. It will disconnect if the negotiated
protocol is different from that in the user profile, even when the negotiated
protocol is stronger than specified. If the peer disconnects right after a successful
authentication, make sure that you specify the correct authentication protocol
when connecting to such an implementation.
25.3 Remote Node Network Layer Options
For the TCP/IP parameters, perform the following steps to edit Menu 11.3 –
Remote Node Network Layer Options as shown next.
Step 1.
Step 2.
Figure 25-3 Menu 11.3 Remote Node Network Layer Options
Menu 11.3 - Remote Node Network Layer Options
IP Options:
IP Address Assignment = Dynamic
Rem IP Addr = 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= N/A
NAT= SUA Only
Address Mapping Set= N/A
Metric= 2
Private= No
RIP Direction= None
Version= RIP-1
Multicast= None
IP Policies=
Enter here to CONFIRM or ESC to CANCEL:
317516-A Rev 00
In menu 11.1, make sure IP is among the protocols in the Route field.
Move the cursor to the Edit IP/Bridge field, press [SPACE BAR] to
select Yes, then press [ENTER] to display Menu 11.3 – Remote Node
Network Layer Options.
Bridge Options:
Ethernet Addr Timeout(min)=
Advertisement
Table of Contents
