Table of Contents
Advertisement
I-6 Command Interpreter
Chart I-1
Sys Commands
ddns
debug
display
restart
logout
cpu
display
Exit Command
Chart I-2
Exit Command
COMMAND
exit
Ethernet Commands
The following chart lists and describes the ether commands. Each of these
commands must be preceded by ether when you use them. For example, type
ether config to display information on the LAN configuration.
Chart I-3
Ether Commands
config
317516-A Rev 00
COMMAND
disp
config <0:Between LAN and
WAN/ 3: IPSec Pass
through/4: Trigger Dial>
<on|off>
<level>
<iface name>
COMMAND
DESCRIPTION
Displays the current NetBIOS filter
modes.
Sets NetBIOS filters.
Enables/disables DDNS service.
Displays DDNS information.
Restarts DDNS.
This command has no effect.
Displays the CPU's utilization.
DESCRIPTION
Ends the command interpreter session.
DESCRIPTION
Displays LAN configuration information.
Advertisement
Table of Contents
