Figure 33-16 Menu 24.7.1 As Seen Using The Console Port - Nortel Contivity 251 User Manual

33.4.8 Uploading Firmware File Via Console Port
Step 1.

Figure 33-16 Menu 24.7.1 as seen using the Console Port

Menu 24.7.1 - System Maintenance - Upload System Firmware
To upload system firmware:
1. Enter "y" at the prompt below to go into debug mode.
2. Enter "atur" after "Enter Debug Mode" message.
3. Wait for "Starting XMODEM upload" message before activating
Xmodem upload on your terminal.
4. After successful firmware upload, enter "atgo" to restart the
Contivity 251.
Warning: Proceeding with the upload will erase the current system
firmware.
Step 2.
33.4.9 Example Xmodem Firmware Upload Using HyperTerminal
Click Transfer, then Send File to display the following screen.
Firmware and Configuration File Maintenance 33-15
Select 1 from Menu 24.7 – System Maintenance – Upload Firmware
to display Menu 24.7.1 – System Maintenance – Upload System
Firmware, then follow the instructions as shown in the following
screen.
Do You Wish To Proceed:(Y/N)
After the "Starting Xmodem upload" message appears, activate the
Xmodem protocol on your computer. Follow the procedure as shown
previously for the HyperTerminal program. The procedure for other
serial communications programs should be similar.
Contivity 251 VPN Switch User's Guide