Table of Contents
Advertisement
Figure 30-7 Menu 21.1.x.1 TCP/IP Filter Rule
Filter #: 1,1
Filter Type= TCP/IP Filter Rule
Active= No
IP Protocol= 0
Destination: IP Addr=
TCP Estab= N/A
More= No
Action Matched= Check Next Rule
Action Not Matched= Check Next Rule
Press ENTER to Confirm or ESC to Cancel:
The following table describes how to configure your TCP/IP filter rule.
Table 30-3 Menu 21.1.x.1 TCP/IP Filter Rule
FIELD
Filter #
This is the filter set, filter rule coordinates, for instance, 2,
3 refers to the second filter set and the third filter rule of
that set.
Filter Type
Use [SPACE BAR] and then [ENTER] to choose a rule.
Parameters displayed for each type will be different.
Choices are TCP/IP Filter Rule or Generic Filter Rule.
Active
Select Yes to activate or No to deactivate the filter rule.
IP Protocol
This is the upper layer protocol, for example, TCP is 6,
UDP is 17 and ICMP is 1. The value must be between 0
and 255. A value of O matches ANY protocol.
IP Source Route
IP Source Route is an optional header that dictates the
route an IP packet takes from its source to its destination.
If Yes, the rule applies to any packet with an IP source
route. The majority of IP packets do not have source
route.
Destination:
Type the destination IP address of the packet you want to
filter. This field is ignored if it is 0.0.0.0.
IP Addr
Menu 21.1.1.1 - TCP/IP Filter Rule
IP Source Route= No
IP Mask=
Port #=
Port # Comp= None
Source: IP Addr=
IP Mask=
Port #=
Port # Comp= None
Log= None
DESCRIPTION
Filter Configuration 30-9
EXAMPLE
TCP/IP Filter Rule
IP address
Contivity 251 VPN Switch User's Guide
1,1
No
(default)
0 to 255
No
(default)
Advertisement
Table of Contents
