en | 44 | DCI 700
67:
Opening the electrical cabinet
9. Perform a safety check in accordance with national legislation (e.g. VDE 100-600 in Germany).
---
5.3.7
Installing the cover for the motor compartment and electrical compartment
1. Attach the protective conductor to the inside of the cover.
2. Slide the cover (2) over the edge of the frame, covering the motor compartment and electrical compartment.
3. Use a square box wrench to lock both locking mechanisms
1.
1.
68:
Installing the cover
---
5.3.8
Final steps
1. Connect the power supply cable to the mains voltage system.
2. Switch on the DCI 700 at the main switch.
---
5.4
Changing circuit board A3
5.4.1
---Separator---
Preparation
1. Close all applications and shut down the operating system.
2. Disconnect the DCI 700 at the main switch and secure against reactivation.
3. Unplug the mains plug or disconnect from mains electricity.
---
1 689 975 289 | 2020-05-06
1
2
4
5
1
2.
2
3
3
and 3).
(1
Robert Bosch GmbH