Bosch DCI 700 Repair Instructions page 41

 61: Frequency converter A1
4. Set frequency converter A1 on the mounting panel. Make sure that no cables are pinched or damaged.
5. Fasten frequency converter A1 to the mounting panel with 4 Torx screws (1) and washers.
6. Insert circuit board A6 (2) into bottom port of the frequency converter A1.
1
 62: Installing the frequency converter A1
7. Connect protective conductor (3) from terminal SL3 to ground and PE terminal of the frequency converter A1.
8. Connect protective conductor (1) from the mounting panel to the ground and PE terminal of the frequency con‐
verter A1.
9. Connect motor connection cable (2) to the frequency converter A1 (refer to circuit diagram).
— Connector wire 1 to connection U of the frequency converter A1.
— Connector wire 2 to connection V of the frequency converter A1.
— Connector wire 3 to connection W of the frequency converter A1.
Robert Bosch GmbH
1
2
1
3
DCI 700 | 41 | en
1 689 975 289 | 2020-05-06