Terminology - Ko Propo EX-1UR Operation Manual

TERMINOLOGY

27MHz
40MHz
AC charger
Alarm
Amplifier
Analog servo
Backlight
Band
Band plate
CPU
Carburetor
Center trim
Channel (CH)
Clutch
Connector
Crystal
Cursor
Cycle
DC charger
Dead band
Decrement angle spacer
Delay
One of frequency ranges that can be used for radio control. There are 12
bands for ground surface and water surface models.
One of frequency ranges that can be used for radio control. There are eight
bands for ground model and five bands for sky model.
A charger to connect to 100V outlet. Charging requires frequently more than
several hours.
AM
A signal form of radio wave to send from a transmitter. Another method is
FM. AM is an abbreviation of amplitude modulation method. When this meth-
od is used, a signal form of transmitter and receiver must match.
A signal to be used as a buzzer on the transmitter. It may be used as means
of warning.
ESC
A general term of a servo model that uses an analog method for control IC of
Servo.
Since LCD (liquid crystal display) does not emit light by itself, visibility is not
good at a dark place. A lamp (light source) is installed on the back of LCD to
solve this problem.
Frequency. This is determined by crystal. The band can be changed within
the same frequency range by replacing the crystal.
A plate that indicates the frequency to others.
IC of the core of a computer used in various applications for digital operation
processing. A microcomputer. It is also called MPU.
Fuel mixing device for engine. It controls the engine speed.
Even if the trim is operated, both ends of rudder angle do not move and only
the neutral position moves in this system.
Number of servos that can be controlled individually with a transmitter. Or its
individual signal number.
An interrupting device located between the output shaft of engine and the
transmission.
Electric contact unit that can be detached and attached.
A component that sets the frequency of transmitter and receiver. It is made
of quartz crystal.
A mark that indicates the character position where the user can currently op-
erate on the display.
This is the interval of repetition of certain movement.
A charger that uses direct current in power supply such as 12V battery or
12V stabilized power supply.
A field where the servo does not react to any operation of wheel and trigger.
A spacer that decreases the steering angle of steering wheel. Operation
amount to the maximum steering angle can be reduced.
Delay of movement or making movement delay.