Setting Abs (T:abs, Abs) - Ko Propo EX-1UR Operation Manual

Press the + key or the – key to change the set
3
value.
The value can be set in the range from B100
through 0 to F100.
If you press the + key and the – key simul-
taneously, the set value is set to 0.
Press the + key or the – key to select the
4
method of preset output.
PUSH: Preset output is performed while the button
is pressed.
TGLE: Preset output is turned on or off each time
the button is pressed.
Press the back (function) key to return to the
5
normal screen.
The setting contents are stored.
Press the button that has been selected in
6
step 2 (or press and hold down the button) to
bring the throttle servo to the preset state.
The throttle position set with this function
is not affected by the setting of other
functions. For example, if this item is set to
F100, even if "T:HiPOT" (throttle high point)
is set to 0, the throttle servo moves to the
F100 position as long as the preset output
is valid.

Setting ABS (T:ABS, ABS)

The pumping amount of ABS (active brake control
system) is set.
This setting is effective if braking locks the wheel,
resulting in a bad posture of car. Also smooth cor-
nering can be obtained.
1) Press the down key or the up key to display
1
"T:ABS."
2) Press the enter key.
To exit the menu, press the back (function) key.
1) Press the + key or the – key to select the
2
button for turning on or off this function.
Select OFF, ET1 to ET5 or BT1.
2) Press the up key.
1) Press the + key or the – key to set the
3
pumping width.
The value can be set in the range of 1 to 100%.
2) Press the up key.
If you press the + key and the - key
simultaneously, the set value is set to 100%.