Table of Contents
Advertisement
Adjusting the steering travel (S:TRAVEL, Steering travel)
The movement amount of steering servo caused
by turning the steering wheel fully is adjusted.
If the value is set to 0%, steering does not
operate.
Set a rudder angle that does not cause undue
force to the servo. A failure may occur.
Press the down key or the up key to display
1
"S:TRAVEL."
Press the + key or the – key to change the set
2
value.
The value can be set in the range of 0 to 150%.
If you press the + key and the – key
simultaneously, the set value is set to 100%.
Press the back (function) key to return to the
3
normal screen or press the down key or the up
key to select another function menu item.
The setting contents are stored.
In the initial state, the ET3 dial can also be
used to set "S:TRAVEL" (steering travel).
However, you can change here only the
ratio to the value set in the above function
menu (40 to 100%).
Even if you press the + key and the – key
simultaneously, however, the set value is
not set to 100%.
ET3 dial
To adjust the movement amount for the right
and the left respectively, adjust "S:BALANC"
(steering balance). (See page 16.)
Adjusting individually the right and left rudder
angles (S:BALANC, Steering balance)
The right and left rudder angles are adjusted re-
spectively. Adjust them, for example, to set the
turning radius to the same value for right and left.
Press the down key or the up key to display
1
"S:BALANC."
Turn the steering wheel in the desired direction
2
for adjusting the rudder angle.
While keeping the steering wheel turned, press
3
the + key or the – key to change the set value.
The value can be set in the range of 40 to 100 for
right and left respectively.
If you press the + key and the - key
simultaneously, the set value is set to 100.
Press the back (function) key to return to the
4
normal screen or press the down key or the up
key to select another function menu item.
The setting contents are stored.
Advertisement
Table of Contents
