Assigning Function To Button (#Setup, Setup) - Ko Propo EX-1UR Operation Manual

Assigning function to button (#SETUP, Setup)

Functions are assigned to the ET levers and the
BT button.
1) Press the down key or the up key to display
1
"#SETUP."
2) Press the enter key.
Press the ET lever or the BT button to which
2
you wish to assign a function.
ET2 lever
BT1 button
ET3 dial
ET5 lever
You can use the up key or the down key to
switch the screen.
Press the + key or the – key to select the
3
function to assign.
Assigning a function to ET1
If the function has been already assigned
to another lever or button, the display blinks
when the function is selected.
ET1 lever
ET4 lever
To assign a function to another lever or button,
4
repeat steps 2 and 3.
Press the back (function) key to return to the
5
normal screen.
The setting contents are stored.
Press a lever or a button to display the screen
6
for the assigned function.
Menu items that can be assigned
OFF None
S:TRM Steering trim
S:TRAVEL Steering travel
S:BALANC Steering balance
S:SUBTRM Steering sub trim
S:TRMRAT Steering trim rate
S:REVERS Steering reverse
S:PUNCH Steering punch
S:CURVE Steering curve
SSPD:SW Steering speed switch
T:TRM Throttle trim
T:HiPOT Throttle high point
T:BRAKE Brake
T:SUBTRM Throttle sub trim
T:TRMRAT Throttle trim rate
T:REVERS Throttle reverse
TPNC:FWD Throttle punch (forward)
TPNC:BAK Throttle punch (reverse)
TCRV:FWD Throttle curve (forward)
TCRV:BAK Throttle curve (reverse)
T:IDLEUP Throttle idle up
TSPD:SW Throttle speed switch
T:ABS ABS
ABS:WID ABS width
ABS:POS ABS position
ABS:CYCL ABS cycle
ABS:DLY ABS delay
ABS:DUTY ABS duty
T:ACCEL Throttle acceleration
ACC:WID Acceleration width
ACC:POSL Acceleration position (low)
ACC:POSH Acceleration position (high)
ACC:CYCL Acceleration cycle
AT:SW Auto start switch
SW:CLICK Stop watch
SW:LAP** Lap timer
DT:CLICK Down timer
3chBTN 3ch control
4chBTN 4ch control