Ko Propo EX-1UR Operation Manual page 60

● Places where large current flows are noise sources.
Place the receiver as far away as possible from the motor, ESC, nicad battery or silicone wires. Espe-
cially, do not route the silicone wires next to the receiver or near the crystal.
Do not place any FET servo blue wire (7.2 V) or any ESC switch wire near the receiver either.
Antenna
Do not position the
receiver or the
antenna on the top
of the motor or the
nicad batteries.
● When fixing the receiver in place, use two or more pieces of double-sided tape on the chassis or on
the mechanical plate so that the receiver body does not touch the chassis or the mechanical plate.
Also ensure that the crystal faces up when installing the receiver.
Do not mount the
receiver directly on
the chassis or
"mechanical deck"
● For an engine car, since vibration of the engine damages the receiver, do not use double-sided tape to
attach the receiver directly to the chassis or the mechanical plate.
Be sure to use the bracket (receiver holder) supplied with the kit or wrap the receiver with thick
sponge.
The silicone wire passes directly
over the receiver.
Do not allow the silicone wires to
cross the antenna.
Do not route the wires near the
antenna.
Do not position the
Use two layers of
crystals on the
double-sided tape. bottom
Bracket
Do not position the antenna
opening or the crystal near the
nicad batteries, motor, or the
carbon chassis.
When mounting the
receiver and
antenna on the
"upper deck",
position them as far
away from the
nicad batteries and
motor as possible.
Always position the
crystal on the top
Sponge