Lap Time Display - Ko Propo EX-1UR Operation Manual

Table of Contents

Advertisement

1) Set the alarm. Press the + key or the – key
6
to set the time for sounding the buzzer.
The value can be set to OFF or in the range of
1min to 99min.
Set the race time.
2) Press the up key.
If you press the + key and the – key simul-
taneously, the set value is set to OFF.
1) Set the pre-alarm. Press the + key or the
7
– key to set the number of seconds to give
pre-alarm (buzzer) before issuing an alarm.
The value can be set to OFF or in the range of
1sec to 30sec.
Set the pre-alarm to be issued before finishing
the race.
2) Press the up key.
If you press the + key and the – key simul-
taneously, the set value is set to OFF.
1) Set the alarm interval. Press the + key or
8
the – key to set the number of seconds of
interval at which an alarm is issued.
The value can be set to OFF or in the range of
00min01sec to 99min59sec.
Set your specific standard lap time.
2) Press the up key.
If you press the + key and the – key simul-
taneously, the set value is set to OFF.
Press the back (function) key to return to the
9
normal screen.
Press the button that has been selected in
10
step 4 to start measurement.
To stop measurement, press again the button (or the
– (stop) key).
When the measurement stops, pressing again
the button (or the + (start) key) will resume the
measurement.
Pressing and holding down the button (or the –
(stop) key) will reset the time to 00:00:00.

Lap time display

The time of each lap is measured and can be
checked after completing driving.
Press the + (start) key or the button that has
1
been assigned in step 4 on page 42 to start
measurement.
If start of measurement by throttle trigger has been
set, pull the throttle trigger.
Press the button for measuring lap time that
2
has been assigned in step 5 on page 42 to
start measurement.
The lap time is stored and displayed for three
seconds. In this period, time measurement continues.
Repeat step 2 to measure the time of each
3
lap.
Press the – (stop) key or the button that has
4
been assigned in step 4 on page 42 to stop
measurement.

Advertisement

Table of Contents
loading

Table of Contents