Drive Management, Iee Cannot Be Identified - Baumuller b maXX 5000 Series Instruction Handbook Manual

6.2
Commissioning procedure IEE
If the b maXX 5000 add-on module MOD has not been identified as correct or if it is not
available, following error message is generated after activating the incremental encoder
emulation.
Figure 10:
NOTE
All error parameters of the incremental encoder emulation can be found in chapter
ZTroubleshooting and fault correction–
34
Instruction handbook b maXX 5000 add-on module MOD
Document No.: 5.19015.01
of 90

Drive management, IEE cannot be identified

n Check the type code of the b maXX 5000, whether the device provides an add-on
module MOD.
Re-boot the device and check if the add-on module MOD is identified correctly,
now.
n The b maXX 5000 with add-on module MOD is damaged if it is still not identified.
For replacement, contact Baumüller Nürnberg GmbH.
from page 81.
Baumüller Nürnberg GmbH