Function Test Iee; Connection Incremental Encoder And Iee - Baumuller b maXX 5000 Series Instruction Handbook Manual

6.2
Commissioning procedure IEE
6.2.3

Function test IEE

The incremental encoder emulation can be tested with b maXX 5000, motor and encoder,
only.
Requirements 1
2
3
Figure 14:
NOTE
If you want to use some other configuration, please turn to examples 2 and 3 in
ure 5–
however.
4
5
6
36
Instruction handbook b maXX 5000 add-on module MOD
Document No.: 5.19015.01
of 90
Drive is in operating state (see parameter manual b maXX 5000). Encoder 1 connect-
ed with X7 Encoder 1 for motor control.
b maXX 5000 switched off again after successful first commissioning.
Connect output of add-on module IEE with input of X8 Encoder 2 (connecting cable
see ZConnecting cable IEE channels–
B
IEE 1
BM5323
310045678
06500141
ENC 1
M
ENC 2

Connection incremental encoder and IEE

on page 27. In the following the above mentioned configuration is described,
Switch on b maXX 5000
Start ProDrive
Choose ProDrive Navigation, „Configuration/Encoder emulation 1"
auf Seite 29).
Baumüller Nürnberg GmbH
ZFig-