Add-On Module Eip; Front View Add-On Module Eip - Baumuller b maXX 5000 Series Instruction Handbook Manual

4.2

Add-on module EIP

4.2 Add-on module EIP
NOTE!
Only devices with type code BM5XXX-XXXX-XX08-00XX provide the add-on module
Modbus/TCP
The module is built-in and cannot be changed.
It is forbidden to remove the yellow front cover.
The Modbus/TCP provides 2 channels .
5000_0322_rev01_int.cdr
Figure 2:
Set values for the incremental encoder emulation can be obtained from the sources given
below:
m Position actual values encoder 1 or encoder 2,
m Position actual values (e. g. internal from positioning)
m Field bus set value (external set via bus),
The signal generated by b maXX can either be used for synchronization of the following
axis, see examples 1 and 3 in
axis by a master control, see example 2 in
20
Instruction handbook b maXX 5000 add-on module MOD
Document No.: 5.19015.01
of 90
Modbus
Modbus
Channel 1
Channel 2

Front view add-on module EIP

see examples 1 and 2 in
see example 3 in ZFigure 5–
ZFigure 5– on page 27
on page 27.
ZFigure 5– on page 27 or for position measuring of the
ZFigure 5– on page 27.
Baumüller Nürnberg GmbH