Lcd Screen Operation - ESAB CIGWELD CutSkill 60 Operating Manual

NOTE
For a secure seal, apply thread sealant to the fitting threads, according to manufacturer's instructions. Do Not use Teflon tape
as a thread sealer, as small particles of the tape may break off and block the small gas passages in the torch.
7. Water Catchment
A water catchment is installed to collect water in the compressed air.
8. Water Release Valve
Press the water release valve upward to release water from the water catchment. Use the spanner supplied in
system package to detach the water catchment from the unit for cleaning.

2.06 LCD Screen Operation

1. Welcome Screen
Welcome Screen will display for 3 seconds when the power source is turned on.
Then Model Name Screen displays for 3 seconds.
2. Main Screen
Main Screen displays setting of cutting current,voltage, trigger mode, cutting mode and output air pressure.
0-5574
OPERATING MANUAL
Figure 2-5: Welcome Screen
Figure 2-6: Model Name Screen
60A
120V
460
Trigger Mode Cutting Mode
Figure 2-7: Main Screen
2-5
CutSkill 60
Current
Voltage
Output Air Pressure
INTRODUCTION