ESAB CIGWELD CutSkill 60 Operating Manual page 18

CutSkill 60
3. Menu Screen
Press the Control Knob to enter Menu Screen. In Menu Screen, the user can set trigger mode, cutting mode,
and gas purge. Exit Menu Screen by selecting Home icon.
1) Trigger Mode Selection Screen
Press the Control Knob when Trigger Mode section is highlighted to enter 2T/4T selection screen.
Turn the Control Knob clockwise or anti-clockwise to change the selection between 2T and 4T, and
press the Control Knob to confirm the selection. Press the Control Knob again to exit Trigger Mode
Selection Screen.
Figure 2-10: 2T Mode Selected
The Trigger Mode control is used to switch the functionality of the torch trigger between 2T (normal)
and 4T (latch mode). In 2T mode, the torch trigger must remain depressed for the cutting output to be
active. Press and hold the torch trigger to activate the power source (cutting). Release the torch trig-
ger switch to cease cutting. 4T mode is mainly used for long cutting runs to reduce operator fatigue.
In this mode the operator can press and release the torch trigger and the output will remain active. To
deactivate the power source, the trigger switch must again be depressed and released, thus eliminating
the need for the operator to hold the torch trigger.
INTRODUCTION
Trigger Mode
Home Icon
Figure 2-8: Menu Screen
Figure 2-9: Trigger Mode Screen Selected
OPERATING MANUAL
Figure 2-11: 4T Mode Selected
2-6
Cutting Mode
Gas Purge
0-5574