ESAB CIGWELD CutSkill 60 Operating Manual page 16

CutSkill 60
2. Control Knob
Turn or press the Control Knob to select from the menu or change values.
To adjust the cutting current:
• Turn clockwise to increase cutting current;
• Turn anti-clockwise to decrease cutting current.
NOTE
In gouging mode, the maximum output current is limited to 50A.
To select an option from the displayed menu:
• Options will be highlighted in sequence at every turn;
• Turn clockwise or anti-clockwise to change selection;
• Press the Control Knob to confirm the selection;
• Select home icon and press Control Knob to exit menu.
3. LCD Screen
A LCD screen is installed on the front panel to display cutting mode, cutting current, air pressure, and error
information. Press the Control Knob for more than 2 seconds to enter the menu for cutting mode selection.
Detailed LCD operation method is introduced in Section 2.05.
4. Work Cable Terminal
Connect work cable to the power source via this Dinse terminal, and the clamp on the other side to the work
piece.
CAUTION
!
Loose terminal connections can cause overheating and result in the male plug being fused in the Dinse terminal.
5. Input Supply ON/OFF Switch
This switch is used to turn the unit ON/OFF. When this switch is turned ON the LCD Screen on the front panel
will illuminate and the fan will run.
6. Gas Inlet Port
The gas inlet port can accept a 1/4" NPT male plug. A Nitto air fitting nipple and a - 1/4" male plug is supplied
in the package for connection of air line to the compressed air.
INTRODUCTION
OPERATING MANUAL
Figure 2-4: LCD Screen
2-4 0-5574