Section 4 System; Operation; Preparations For Operating - ESAB CIGWELD CutSkill 60 Operating Manual

4.01 Preparations for Operating

At the start of each operating session:
WARNING
!
Disconnect primary power at the source before assembling or disassembling power supply, torch parts, or torch and leads
assemblies.
A. Torch Parts Selection
Check the torch for proper assembly and appropriate torch parts. The torch parts must correspond with the
type of operation, and with the amperage output of this power supply. Use only genuine Cigweld parts with
this torch.
B. Torch Connection
Check that the torch is properly connected. Refer to Section 3.06 for details.
0-5574
OPERATING MANUAL

SECTION 4 SYSTEM:

OPERATION

Worn Electrode Worn Cutting Tip
A-13888
Figure 4-1: Torch Parts Selection
O-Ring
Diffuser
Electrode
Tip
Shield Cup
Standoff Guide
Worn Gouging Tip
4-1
CutSkill 60
OPERATION