Installation Sequence; Verify Site Conditions - Canon imagePRESS C800 Series Technical & Service Manual

Installation sequence

This chapter describes the installation sequence for the PRISMAsync for imagePRESS C800
Series controller.
Because the PRISMAsync is connected to the customer's network please coordinate your
installation with the network administrator at the customer site.
NOTE
Make sure the PRISMAsync is connected to the host machine before entering Engine Service
mode.
Procedure
1. Verify site conditions on page 15
Assemble the Operator panel on page 17
2.
Unpack the PRISMAsync on page 18
3.
4. Install the PRISMAsync supports/pedestals on page 19
5. Install the DIP-SW PCB and the Open I/F PCB on page 20
6. Connect the PRISMAsync on page 21
7. Finish the installation on page

Verify site conditions

Introduction
Before installing the PRISMAsync controller check the site conditions.
Host Machine
• Is the host machine configured for use with the PRISMAsync controller? For the proper
settings, see the documentation that comes with the host machine.
• Is space available for the PRISMAsync controller behind the host machine? The PRISMAsync
controller is placed behind the host machine. Be sure that there is enough room for servicing
either the host machine or the PRISMAsync controller. You may need to move the host
machine away from the wall so that interface connectors are accessible.
• Check if the interface cables between host machine and PRISMAsync controller are present.
• One data cable must be delivered together with the host machine.
• One Ethernet cross cable is delivered with the PRISMAsync controller.
Power & Network
• Is a dedicated, grounded electrical outlet for the PRISMAsync controller available near the host
machine?
• Locate the grounded electrical outlet that will supply power to the PRISMAsync controller.
Do not run the PRISMAsync controller and the host machine on the same circuit.
• Do not plug the PRISMAsync controller into a switchable wall outlet. This can result in the
PRISMAsync controller being turned off accidentally.
• Do not plug the PRISMAsync controller into a circuit with heating or refrigeration equipment
(including water coolers).
• Do not pull on the cable when unplugging the PRISMAsync controller. Pull the plug instead.
• Make sure that there is a wired network connection available at installation time.
NOTE
A wireless network cannot be used with the PRISMAsync controller.
25.
Installation sequence
Chapter 3 - Installation 15