Install/Replace The Ethernet Board - Canon imagePRESS C800 Series Technical & Service Manual

Install/Replace the Ethernet board

Install/Replace the Ethernet board
The extra Ethernet board (Intel PRO/1000 GT Desktop Adapter) is needed when IPDS functionality
is enabled (Extra license). The board is needed for the Codishell tool to analyse IPDS-problems. It
can also be used to connect the laptop to the PRISMAsync for imagePRESS C800 Series.
NOTE
When servicing components of the PRISMAsync for imagePRESS C800 Series always wear a
grounded strap around your wrist, to avoid electrostatic discharge that will harm your
equipment.
Step Action
1 Remove side cover and middle bracket.
• Follow the instructions as described in
Unpack the new board.
2
Remove the fifth metal bracket (starting from the CPU).
3
• Use a Philips screwdriver to remove the bracket..
Place the board in the PCI connector.
4
• Firmly press the board in the PCI connector.
5 Fasten the Ethernet board.
• Fasten the board with a single screw on the PCI bracket side with a Philips screw-
Re-install middle bracket and side cover.
6
• Make sure the fixing on the middle bracket is in position. It should fit exactly on the
7 Re-install system software
• If the Ethernet board is installed for the first time (no replacement) there will be no
76 Chapter 7 - Service procedures
NOTE
Make sure to use the indicated slot.
driver.
Ethernet board.
driver installed for it. Therefore you have to re-install the PRISMAsync software.
Access internal components on page 68.