Appendix; Connection/Installation Checklist - Canon CR-G100 Instruction Manual

Ip camera controller

Table of Contents

6 Appendix

Use the following checklist to verify correct operation after connecting/installing the IP controller. This checklist is

applicable only when using the IP controller without a CR-S700R Robotic Camera Head. When using a camera head,

refer to the checklist in the CR-S700R instruction manual.

Connections

The IP controller is securely mounted on a stable location.

All the necessary safety/drop-prevention measures are installed.

Cables are connected to the correct terminal/connector.

Cables/connectors are firmly plugged all the way in.

There is enough available recording space on the card inserted in the camera.

The eyepiece camera is correctly set up according to the manufacturer's instructions and its

focus is correctly adjusted.

The IP controller is correctly connected to a network and power supply at the shooting

location.

Web setup tool

The password and network settings were correctly configured after turning on the

IP controller.

Connected devices are correctly registered.

Underslung mode is turned on/off according to the installation position.

The camera and lens are correctly configured (physical switches and controls, menu

settings).

The IP controller is set to READY status.

Camera Remote application CR-A100

The wide view camera's image is displayed correctly.

The eyepiece camera's image is displayed correctly.

The eyepiece camera's image is sharp and clear. (If not, correct as necessary, performing the

dioptric adjustment on the main capture camera)

All the operations can be correctly controlled with the Camera Remote application.

The images recorded on the main capture camera's card can be correctly acquired.

Images are correctly transferred to the FTP server.

Check item

Connection/Installation Checklist

Checked

▢

Table of Contents