Replace The Ddi Board - Canon imagePRESS C800 Series Technical & Service Manual

Replace the DDI board

The DDI board handles the interfacing between the copier and the PRISMAsync for imagePRESS
C800 Series.
Only replace the board if you have checked the cables connected to the board.
NOTE
When servicing components of the PRISMAsync for imagePRESS C800 Series always wear a
grounded strap around your wrist, to avoid electrostatic discharge that will harm your
equipment.
Step Action
Remove side cover and middle bracket.
1
Follow the instructions as described in
2 Unplug the power connector and internal connectors of the board.
3 Remove the screw of the metal PCI bracket.
Use a small Philips screwdriver to remove the screw used to mount the bracket to the
backside of the PRISMAsync for imagePRESS C800 Series.
4 Remove the PCI card from it's slot Hold the PCI card by the two top corners. Pull it
straight out of the socket.
Take the board out of the PRISMAsync for imagePRESS C800 Series.
5
Unpack the new board.
6
Place the board in the PCI-E connector.
7
Firmly press the board in the PCI-E connector. Use the PCI-E 3 port.
8 Fix the DDI board.
Fix the board with a single screw on the PCI bracket side with a Philips screwdriver.
9 Plug the internal connectors to the board.
10 Re-install middle bracket and side cover. Take care that the fixing on the middle
bracket is in position. It should fit exactly on the DDI-board.
Access internal components on page
Chapter 7 - Service procedures
Replace the DDI board
68.
71