Replace The Ddr3 Modules - Canon imagePRESS C800 Series Technical & Service Manual

Replace the DDR3 modules

Replace the DDR3 modules
The MB950 board supports four DDR3 memory socket for a maximum total memory of 16GB of
the DDR3 DIMM memory type.
The PRISMAsync for imagePRESS C800 Series is equipped with 4x4GB DIMM (total memory size
16GB).
NOTE
When servicing components of the PRISMAsync for imagePRESS C800 Series always wear a
grounded strap around your wrist, to avoid electrostatic discharge that will harm your
equipment.
Step
1
2
3
4
5
74 Chapter 7 - Service procedures
Action
Remove side cover and middle bracket.
• Follow the instructions as described in
Open the clips by pressing them outward.
• Firmly press on the clips on the left and the right side of the connector. The DDR3
module will be lifted out of the connector.
Align the DDR3 module with memory slot.
Install the DDR3 module in memory slot
• Gently push the DDR3 module in an upright position until the clips of the slot
close, to hold the DDR3 module in place when the DDR3 module touches the bot-
tom of the slot.
[15] Removing DDR3 module
Re-install middle bracket and side cover.
Access internal components on page
[16] Inserting DDR3 module
68.