Canon imagePRESS C800 Series Technical & Service Manual page 78

Replace the Base controller
Step Action
10 Install the supports/pedestals
• See:
11 Connect the cables at the backside of the controller
• See:
Install old HDDs
12
• If you have removed the HDDs from the defect controller you can mount them in
13 Install system software
• In case that the hard disks were not exchanged, you have to install the latest PRIS-
Restore a backup
14
• If you have a backup of the system before it crashed you can restore it now. All set-
15 Re-host and install licenses
• Since the MAC-address of the PRISMAsync controller has changed it is necessary
78 Chapter 7 - Service procedures
Install the PRISMAsync supports/pedestals on page 19
Connect the PRISMAsync on page 21
the new controller. First remove the HDDs that are in the new controller. Be aware
that you mount the disks on the same position as they were mounted inn the defect
controller. See also "Hard Disk Drives".
MAsync software.
tings will be restored except the licenses because they belong to the "old" control-
ler.
to re-host the licences. Please contact your local service organization for the new
licenses.