Maintenance And Service - Canon imagePRESS C800 Series Technical & Service Manual

Maintenance and Service

Introduction
This topic describes the different maintenance and service screens for the PRISMAsync.
The maintenance screen displays the following information.
• Maintenance:
• [Start maintenance] to enter
• [Go to service mode] to enter
• [Allow remote assistance] to allow to the system by a service help desk.
• Counters:
• [Reset day counters]
• [Print billing counter report]
• Counters
Each counter has two values. The first value displays the total number of prints that have been
made since the machine was installed. The second value displays the same counters but this
value can be reset to "0" (e.g. reset the day counters at the beginning of a working day).
In Service Mode it is possible to select which counters to display and additional toner bottle
counters can be added.
Maintenance mode
When you push the [Start maintenance] button you will enter a mode in which you can perform
some adjustments to the system. All the adjustments are guided by a wizard to make your job
easier. A password is required to enter the maintenance mode (default: 12345).
1. Stacker: Replace flip rings
A wizard to help you replace the four flip rings of the High Capacity Stacker-G1
2. Auto colour mismatch correction
You can automatically correct colour mismatching that occurs in the output. The Auto colour
mismatch correction aligns the position of the four different colours.
3. Clean the clean roller (main unit)
If dirt or stripes appear on printed output, clean the roller inside of the main unit. The
procedure takes approximately one minute to finish
Maintenance mode on page
System service and engine service mode on page
Maintenance and Service
37.
Chapter 4 - Using the PRISMAsync
38.
37