Check External Connections - Canon imagePRESS C800 Series Technical & Service Manual

Check external connections

Before opening the PRISMAsync controller first check the external connections.
Check the following:
Procedure
1.
Power cable is connected to the PRISMAsync controller and is switched on
2.
Network cable is connected and status LED is blinking.
3.
Crossover Ethernet cable (lower network port) is connected to the host machine.
4.
Crossover Ethernet cable (lower network port) and normal Ethernet cable (upper network port)
are connected.
5. Both data cables are connected correctly between the PRISMAsync controller and host machine.
6. USB cable from the PRISMAsync controller to operator panel is connected.
7.
DVI cable from the PRISMAsync controller (Left DVI port) to operator panel is connected.
8.
15-pin D-sub cable from the PRISMAsync to the operator panel is connected.
9.
9-pin D-sub cable from the PRISMAsync to Operator attention light is connected
10.
The cables at the backside of the Operator panel are connected. Remove the cover on the
backside of the operator panel to check.
Check external connections
Chapter 10 - Troubleshooting 121