Table of Contents
Advertisement
The Troubleshooting Guide, shown below, is included to
help you quickly locate problems that can happen using
your 6510 Disc. Follow all safety precautions stated in the
previous sections when making any adjustments to your
machine.
PROBLEM
TRACTOR TRYING TO SIDE DRAFT
UNIT TRAILING OFF TO THE LEFT
UNIT TRAILING OFF TO THE RIGHT
UNIT NOT DISCING LEVEL
DISC GANG PLUGGING
DISC GANG WILL NOT TURN OR
PUSHES SOIL
NOT FILLING FURROW ON LEFT SIDE
OF UNIT
Troubleshooting Guide
PROBABLE CAUSE
SIDE DRAFT LINKAGE OR CYLINDER
ON 6510 NOT PROPERLY SET
FIXED OR PINNED DRAWBAR ON
TRACTOR
SWINGING DRAWBAR ON TRACTOR
AGAINST STOP ON LEFT HAND SIDE
FRONT GANG IS RUNNING TOO DEEP
SIDE DRAFT LINKAGE OR CYLINDER
ON 6510 NOT PROPERLY SET
REAR GANG IS RUNNING TOO DEEP
SIDE DRAFT LINKAGE OR CYLINDER
ON 6510 NOT PROPERLY SET
UNIT IS NOT LEVEL FROM FRONT TO
REAR
SCRAPERS SET TOO FAR FROM DISC
BLADE
OPERATING DEPTH TOO DEEP
CONDITIONS TOO WET
SCRAPERS SET TOO TIGHT
DEPTH SET TOO DEEP FOR LOOSE OR
WET CONDITIONS
GANG BEARING FAILURE
SPEED TOO SLOW FOR SOIL
CONDITIONS
REAR OF DISC TRACKING TOO FAR TO
THE RIGHT
TRACTOR BEING DRIVEN TOO FAR TO
THE RIGHT
Chapter 6
SOLUTION
ADJUST SIDE DRAFT LINKAGE OR
CYLINDER ON 6510 TO PROPER
LENGTH
USE SWINGING DRAWBAR
LENGTHEN SIDE DRAFT LINKAGE OR
CYLINDER ON 6510
ADJUST LEVELING CYLINDER TO
RAISE FRONT GANG
SHORTEN SIDE DRAFT LINKAGE OR
CYLINDER ON 6510
ADJUST LEVELING CYLINDER TO
LOWER REAR GANG
LENGTHEN SIDE DRAFT LINKAGE OR
CYLINDER ON 6510
ADJUST LEVELING CYLINDER TO
ACHIEVE LEVEL UNIT
ADJUST SCRAPERS TO MEET DISC
BLADE CLOSER AND EVENLY
RAISE UNIT
WAIT UNTIL CONDITIONS ARE MORE
FAVORABLE
READJUST SCRAPERS
RAISE UNIT OR WAIT UNTIL
CONDITIONS ARE MORE FAVORABLE
REPLACE BEARING
INCREASE SPEED
LENGTHEN SIDE DRAFT LINKAGE OR
CYLINDER ON 6510
DRIVE TRACTOR SO THAT LEFT
FRONT DISC IS IN THE EDGE OF THE
FURROW
6-1
Advertisement
Table of Contents
