Assembly Instructions - Landoll 875 Series Operator's Manual

ASSEMBLY INSTRUCTIONS

It is very important that your new 875 Series
Tilloll be properly assembled, adjusted and lubri-
cated before use. Illustrations to assist with the as-
sembly process are provided in Section 2, "Stan-
dard Specifications". They show proper shank,
disc gang and mounting bracket spacings. Illustra-
tions in this section show proper assembly proce-
dures. Remove paint from grease fittings. Replace
any grease fittings that are damaged or missing. Be
sure to return screws, clips, etc., to their original lo-
cations.
To insure alignment of assemblies, leave the
nuts loose until completion of final assembly. Use
lock washers or flatwashers as specified. Spread all
cotter pins.
After completion of final assembly, tighten all
nuts evenly to prevent misalignment, distortion or
binding. Tighten all screws and nuts to the recom-
mended torques shown in Table 2-1, "Standard
Bolt Torques".
DANGER
TO PREVENT ACCIDENTAL LOWER-
ING:
1. ALL HYDRAULICALLY ELEVATED
EQUIPMENT MUST BE LOCKED OUT
USING THE CYLINDER LOCKOUTS:
2 . L O W ER EQ UI PM E NT TO T H E
G R O U N D WH ILE SE RV IC ING OR
WHEN IT IS IDLE.
FAILURE TO TAKE MEASURES TO
PREVENT ACCIDENTAL LOWERING
MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH.
DANGER
DISC BLADES ARE EXTREMELY
SHARP. EXERCISE EXTREME CARE
WHEN WORKING ON OR NEAR DISC
BLADES. DO NOT ALLOW DISCS TO
ROLL OVER OR FALL ONTO ANY BOD-
I L Y P A R T. D O
WRENCHES TO SLIP WHEN WORKING
NEAR DISC BLADES. NEVER PUSH
WRENCHES TOWARD DISC BLADES.
DO NOT CLIMB OVER MACHINE
ABOVE DISC BLADES. FAILURE TO
STAY CLEAR OF DISC BLADE EDGES
CAN CAUSE SERIOUS PERSONAL IN-
JURY OR DEATH.
WARNING
DO NOT ATTEMPT TO LIFT HEAVY
PARTS (SUCH AS THE FRAME, DISC
GANGS, ROCK SHAFT, AND PULL
HITCH) MANUALLY. USE A HOIST OR
A FORK LIFT TO MOVE THESE PARTS
INTO POSITION.
CAUTION
BE SURE TO BLEED THE HYDRAULIC
SYSTEM OF ALL AIR IN LINES AFTER
INSTALLATION. FAILURE TO BLEED
THE SYSTEM OF ALL AIR CAN RE-
SULT IN PERMANENT EQUIPMENT
DAMAGE.
3
N O T A L LOW
3-1