Table of Contents
Advertisement
Step 5.
Install the M.2 drive on the M.2 adapter.
Figure 98. M.2 drive installation
a.
Insert the M.2 drive at an angle of approximately 30 degrees into the connector.
b.
Rotate the M.2 drive down until the notch
c.
Slide the retainer forward (toward the connector) to secure the M.2 drive into place.
Step 6.
Connect the cables to the system board. See "M.2 drives" on page 65.
After you finish
Use the Lenovo XClarity Provisioning Manager to configure the RAID. For more information, see:
https://sysmgt.lenovofiles.com/help/topic/LXPMv3/LXPMv3_introduction.html
Middle drive cage replacement
Use this information to remove and install the middle 2.5-inch or 3.5-inch drive cage.
• "Remove the middle 2.5-inch drive cage" on page 242
• "Install the middle 2.5-inch drive cage" on page 244
• "Remove the middle 3.5-inch drive cage" on page 246
• "Install the middle 3.5-inch drive cage" on page 249
Remove the middle 2.5-inch drive cage
Use this information to remove the middle 2.5-inch drive cage.
About this task
Attention:
• Read "Installation Guidelines" on page 129 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
A video for this task is available at:
ThinkSystem SR665 Maintenance Manual
242
catches on the lip of the retainer
1
.
.
2
Advertisement
Table of Contents
