Table of Contents
Advertisement
Step 4.
Check the rearwall matrix and decide which rearwall brackets need to be installed or removed for
installing your riser assemblies. See "Rearwall bracket replacement" on page 306
Step 5.
Install a riser 1 assembly or riser 2 assembly. The illustration shows installing the riser 1 assemblies.
The procedure is the same for installing riser 2 assemblies.
Figure 168. Riser 1/2 assembly installation (three-slot riser bracket)
Figure 169. Riser 1/2 assembly installation (one-slot riser bracket)
1. Align the riser adapter in the riser cage with the PCIe riser slot on the system board. Carefully
press the PCIe adapter straight into the slot until it is securely seated and its bracket also is
secured.
2. (Optional) If there is one screw on the riser cage, tighten the screw.
After you finish
1. Refer to Chapter 3 "Internal cable routing" on page 57 to connect any cables to the PCIe adapters.
2. Complete the parts replacement. See "Complete the parts replacement" on page 397.
.
Chapter 4
Hardware replacement procedures
353
Advertisement
Table of Contents
