Procedure
Step 1.
Touch the static-protective package that contains the memory module to any unpainted surface on
the outside of the server. Then, take the memory module out of the package and place it on a
static-protective surface.
Step 2.
Locate the required memory module slot on the system board.
Note: Ensure that you observe the installation rules and sequence in "Memory module installation
rules" on page 254.
Step 3.
Install the memory module into the slot.
Figure 111. Memory module installation
a.
Open the retaining clip on each end of the memory module slot.
Attention: To avoid breaking the retaining clips or damaging the memory module slots, open
and close the clips gently.
b.
Align the memory module with the slot, and gently place the memory module on the slot with
both hands.
c.
Firmly press both ends of the memory module straight down into the slot until the retaining
clips snap into the locked position.
Note: If there is a gap between the memory module and the retaining clips, the memory
module has not been correctly inserted. In this case, open the retaining clips, remove the
memory module, and then reinsert it.
.
Chapter 4
Hardware replacement procedures
257