Table of Contents
Advertisement
Procedure
Step 1.
Prepare your server.
1. Remove the top cover. See "Remove the top cover" on page 392.
2. Disconnect the cables from the rear drive backplane. See Chapter 3 "Internal cable routing" on
page 57.
3. Remove all the installed drives and fillers (if any) from the drive bays. See "Remove a hot-swap
drive" on page 176.
Step 2.
Remove the 4 x 3.5-inch rear drive cage.
Figure 150. Removing the 4 x 3.5-inch reard rive cage
1. Twist and pull out the blue plungers.
2. Slide the drive cage towards the rear of the chassis to release it.
Step 3.
If needed, remove the backplane from the drive cage. See "Remove the middle or rear 3.5-inch-
drive backplane" on page 198.
After you finish
If you are instructed to return the old drive cage, follow all packaging instructions and use any packaging
materials that are provided.
ThinkSystem SR665 Maintenance Manual
326
Advertisement
Table of Contents
