Table of Contents
Advertisement
Step 3.
Install the 7mm drive backplane at the bottom.
Figure 80. 7mm drive backplane installation (bottom)
a.
Align the pin on the cage and slightly slide the backplane into the cage until it is fully seated.
b.
Install the screw as shown.
Step 4.
Install the 7mm drive backplane on the top.
Figure 81. 7mm drive backplane installation (top)
a.
Put the backplane down on the cage as shown.
b.
Install the two screws to secure the backplane in place
Step 5.
Connect the cables to the system board. See "7mm drives" on page 64.
After you finish
1. Reinstall all the drives and fillers (if any) into the drive bays. See "Install a hot-swap drive" on page 178.
2. Complete the parts replacement. See "Complete the parts replacement" on page 397.
.
Chapter 4
Hardware replacement procedures
207
Advertisement
Table of Contents
