Table of Contents
Advertisement
Procedure
Step 1.
If the security bezel is installed, remove it first. See "Remove the security bezel" on page 362.
Step 2.
Slide the release latch to the left to open the drive tray handle.
Figure 62. Opening the drive tray handle
Step 3.
Grasp the handle and slide the drive out of the drive bay.
Figure 63. Hot-swap drive removal
After you finish
1. Install the drive filler or a new drive to cover the drive bay. See "Install a hot-swap drive" on page 178.
2. If you are instructed to return the old hot-swap drive, follow all packaging instructions and use any
packaging materials that are provided.
.
Chapter 4
Hardware replacement procedures
177
Advertisement
Table of Contents
