Table of Contents
Advertisement
Procedure
Step 1.
Touch the static-protective package that contains the new riser card to ay unpainted surface on the
outside of the server. Then, take the new riser card out of the package ad place it on a static-
protective surface.
Step 2.
Remove a B1 or B2 rearwall bracket.
Note: The illustration shows only the removal of B1 rearwall bracket, the B2 rearwall bracket can
be removed in the same way.
Figure 144. B1 rearwall bracket removal
a.
Remove the two screws.
b.
Remove the bracket from the chassis in the direction as shown.
After you finish
1. Remove or install a rear drive cage or riser assemblies. See
• "PCIe adapter and riser assembly replacement" on page 345
• "Rear drive cage replacement" on page 320
2. Complete the parts replacement. See "Complete the parts replacement" on page 397.
.
Chapter 4
Hardware replacement procedures
313
Advertisement
Table of Contents
