4. To adjust the seat springs, move the 2 rubber stops
below the seat as given in the illustration. Put the 2
rubber stops in the front, middle or rear holes below
the seat.
4.6 Tire pressure
Make sure to have the correct tire pressure on all 4 tires.
Technical data on page 72 .
Refer to
4.7 To attach the cutting deck
1. Park the product on level ground.
2. Apply the parking brake.
3. Set the lift lever for the cutting deck in transport
position.
4. Move the weight transfer lever up to disengage the
weight transfer.
914 - 003 - 28.03.2019
5. Set the lift lever for the cutting deck in the mow
position.
6. Stop the engine.
7. Set the cutting height lever to the servicing position.
8. Align the cutting deck to the equipment frame.
9. Push the cutting deck into the equipment frame
forward until it stops.
Assembly - 11