Husqvarna R419TsX AWD Workshop Manual page 62

3. Remove the screws that hold the pulley. Lock the
blade with a wooden block.
4. Remove the pulley. Use a puller if it is necessary.
5. Loosen the 4 screws that hold the blade bearing and
remove the bearing assembly from the cutting deck.
6. Put the bearing housing in a vise and remove the
blade and washers.
62 - Repair instructions
7. Remove the protective washer.
8. Make a mark on one end of the shaft. Push out the
shaft with a puller. Tap out the bearing and remove
the spacer.
9.6.9 To sharpen and balance the blades
WARNING: Use protective gloves to prevent
injury.
1. Remove the blades. Refer to
on page 61 .
2. Put the blades in a vise.
3. Sharpen the blades with a file.
To replace the blades
914 - 003 - 28.03.2019