Husqvarna R419TsX AWD Workshop Manual page 60

6. Move the end of the chain tension spring (A) from
the screw (B).
7. Remove the screw (B) and nut (C) for the chain
tension spring.
8. Remove the 2 screws that hold the front end of the
weight transfer spring.
9. Tilt the front end of the weight transfer spring (A).
The front end of the weight transfer must stay
between the guide plates (B).
A
60 - Repair instructions
10. Pull the weight transfer forward into the steering
C
B
A
11. Lift the rear end of the weight transfer out of the
12. Assemble in opposite sequence.
9.6.5 To adjust the weight transfer of the cutting
B
deck
1. Remove the weight transfer from the product. Refer
2. Put the weight transfer hook in a vise.
column to the left of the central steering unit (A).
frame tunnel and pull it rearward, below the fuel
tank.
2
1
to To remove the weight transfer on page 59 .
A
914 - 003 - 28.03.2019