To Adjust The Parallelism Of The Cutting Deck - Husqvarna R419TsX AWD Workshop Manual

4.10 To adjust the parallelism of the cutting
deck
1. Park the product on hard level ground.
2. Apply the parking brake.
3. Move the weight transfer lever down.
4. Move the lift lever rearward and lift the cutting deck
to the transport position to engage the lift support.
5. Move the lift lever forward and lower the cutting deck
to the mow position.
6. Set the cutting height lever to the servicing position.
7. Remove the clevis joint on the front end of the height
adjustment stay. Move the height adjustment stay to
the side.
914 - 003 - 28.03.2019
8. Loosen the locknuts on the lift stay.
9. Turn the adjustment nut on the lift stay to adjust the
length of the lift stay. Increase the length to lift the
rear edge of the cover. Decrease the length to lower
the rear edge of the cover.
10. Tighten the locknuts on the lift stay.
11. Loosen the locknut (A) on the clevis joint on the
height adjustment stay. Turn the clevis joint (B) on
the height adjustment stay to adjust the length of the
height adjustment stay. Make sure that the clevis
joints align with the correct hole on the frame of the
cutting deck.
Note: The 2 ends of the height adjustment stay each
have a clevis joint. You get the same result
independently of which clevis joint you adjust.
A
B
Assembly - 13