Husqvarna R419TsX AWD Workshop Manual page 69

11. Install the main belt in opposite sequence.
Note: Make sure that the pulleys are easy to turn to
prevent wear on the belt.
9.9.5 To replace the equipment belt
Note: It is not necessary to remove the nuts or the belt
pulleys to replace the equipment belt.
1. Remove the cutting deck. Refer to
cutting deck on page 12 .
2. Remove the equipment frame cover. Refer to
remove and install the equipment frame cover on
page 25 .
3. Loosen the nuts on the 2 front belt pulleys.
4. Tilt the 2 front belt pulleys and remove the
equipment belt.
5. Assemble in opposite sequence.
Note: Make sure that the pulleys are easy to turn to
prevent wear on the belt.
9.9.6 To replace the cutting deck belt
1. Remove the cutting deck. Refer to
cutting deck on page 12 .
2. Remove the front cover. Refer to
install the front cover of the cutting deck on page 24 .
914 - 003 - 28.03.2019
3. Remove the side covers on the cutting deck. Refer
4. Loosen the tension spring and lift the belt.
To remove the
To
5. Assemble in opposite sequence.
Note: Make sure that the pulleys are easy to turn to
prevent wear on the belt.
To remove the
To remove and
To remove and install the side cover of the cutting
to
deck on page 25 .
Repair instructions - 69