Husqvarna R419TsX AWD Workshop Manual page 30

9.1.3.3 To lubricate the parking brake cable
1. Remove the frame tunnel cover and the left side
To remove the covers on page 24 .
cover. Refer to
2. Push the rubber casings (A) in the direction of the
ends of the parking brake cable.
A
3. Lubricate the ends of the parking brake cable with
engine oil.
4. Push the parking brake pedal 3 times and lubricate
the parking brake cable again.
5. Attach the rubber casings.
6. Attach the left side cover and the frame plate.
9.1.4 Wheels
9.1.4.1 To disassemble and assemble the wheel hub
1. Remove the cutting deck. Refer to
cutting deck on page 12 .
2. Put supports below the product. Refer to
supports below the product on page 7 .
3. Remove the wheel nuts.
4. Remove the wheel.
5. Remove the snap ring and washer in the center of
the wheel hub.
30 - Repair instructions
6. Remove the screws on the wheel hub.
7. Remove the snap ring.
To remove the
To put
8. Remove the wheel hub.
9. Examine the key in the shaft. Replace the key if it is
10. Assemble in opposite sequence.
9.1.5 Rear axle
9.1.5.1 To disassemble the pivoting rear axle
1. Remove the front skid plate.
2. Make marks on the hydraulic couplings on the
damaged.
hydraulic hoses. This makes it easier to connect
them correctly when you assemble the pivoting rear
axle.
914 - 003 - 28.03.2019