Husqvarna R419TsX AWD Workshop Manual page 68

10. Remove the bracket on the PTO clutch.
11. Disconnect the connector of the PTO clutch.
12. Pull the transmission belt off the engine pulley and
move it below the engine belt pulley.
13. Pull out the transmission belt through the opening
below the pivot bearing and past the belt tensioner.
14. Install in opposite sequence.
Note: Make sure that the pulleys are easy to turn to
prevent wear on the belt.
9.9.4 To remove and install the main belt
1. Remove the cutting deck. Refer to
cutting deck on page 12 .
2. Put the equipment frame in the lowest position.
68 - Repair instructions
3. Remove the lower belt covers. Refer to
4. Loosen the spring on the belt tensioner.
5. Remove the right and the left footrest plate. Refer to
6. Remove and install the intermediate pulley cover.
7. Remove the screws (A) of the intermediate pulley
8. Tilt the intermediate pulley bracket rearward (B).
9. Remove the equipment belt (A) from the
To remove the
10. Remove the main belt (B) from the intermediate
the lower belt covers on page 27 .
To remove and install the right footrest plate on
page 25 .
To remove and install the intermediate
Refer to
pulley cover on page 27 .
bracket on the two sides of the frame tunnel.
A
intermediate pulley.
B
A
pulley.
To remove
B
914 - 003 - 28.03.2019