Husqvarna R419TsX AWD Workshop Manual page 59

9.6.2 To put the cutting deck in mow position
1. Hold the front edge of the cutting deck (A) with one
hand. Push the cutting deck in the direction of the
product.
2. Pull the lock handle (B) with your other hand to
disengage the locked position of the cutting deck.
B
3. Fold down the cutting deck (C) until it is level to the
ground.
4. Pull the lock handle and push the cutting deck in the
direction of the product until it stops.
5. Push down the lock handle.
9.6.3 To examine the ground pressure of the
cutting deck
A correct ground pressure makes sure that the cutting
deck moves along the surface but does not press too
hard against it.
1. Make sure that the air pressure in the tires is correct.
Technical data on page 72 .
Refer to
2. Make sure that the weight transfer is engaged.
3. Park the product on a level surface.
4. Lower the cutting deck to mow position.
5. Put a scale below the front edge of the cutting deck.
6. Put a wooden block between the cutting deck and
the scale. Make sure that the support wheels do not
touch the ground.
914 - 003 - 28.03.2019
7. Adjust the weight transfer if the ground pressure is
9.6.4 To remove the weight transfer
1. Remove the cutting deck. Refer to
2. Disengage the weight transfer.
A
C
3. Remove the seat.
4. Remove the frame tunnel cover, the left and right
5. Remove the spring attached to the rear end of the
not between 12 and 15 kg (26.5-33 lb). Refer to
adjust the weight transfer of the cutting deck on
page 60 .
cutting deck on page 12 .
footrest plates and the steering column cover. Refer
To remove the covers on page 24 .
to
weight transfer.
To
To remove the
Repair instructions - 59