Husqvarna R419TsX AWD Workshop Manual page 53

3. Attach the front speed adjustment rod.
4. Lightly lubricate the pipe couplings before you
assemble.
5. Lubricate the axles with corrosion protection before
you attach the wheels.
6. Fill the transmission oil tank with oil and bleed the
hydraulic system. Refer to
72 .
7. Do a check of and adjust the parking brake cable.
To examine the parking brake on page 29 .
Refer to
8. Do a check of and adjust speed coordination
between the front wheels and rear wheels. Refer to
To adjust the wheel speed on AWD products on
page 39 .
9.5.14.3 To disassemble the rear transmission
Work procedure on page 47 .
Obey the directions in
CAUTION: Hold the hydraulic connection nuts
with a wrench to prevent damage to the pipes or
elbow nipples.
Note: A small quantity of oil can leak although the
transmission is drained.
1. Put support below the product. Refer to
supports below the product on page 7 .
2. Remove the rear wheels. Refer to
and assemble the wheel hub on page 30 .
3. Drain the oil of the rear transmission. Refer to
procedure on page 47 .
914 - 003 - 28.03.2019
Technical data on page
To put
To disassemble
Work
4. Remove the filter lid and pull out the filter. Replace
Technical data on page 72 .
the filter. Refer to
5. Make marks on the hydraulic hoses to make it easier
to connect them correctly when you assemble them.
6. Disconnect the hydraulic hoses from the rear
transmission.
7. Attach protective plugs in the transmission and the
hoses.
8. Open the clamps for the hoses on the transmission
oil tank and remove the transmission oil tank.
9. Loosen the cable and the speed control rod from the
lever.
Repair instructions - 53